不管是什么工業使用物品，如果在使用的時候有什么問題的話是需要及時的解決的，有些缺陷不是我們隨隨便便就能夠解決的，要依靠專業的設備來解決，浸滲設備就是這么一種什么，它對于很多物品的氣孔，疏松有很好的解決方法，下面就為大家來詳細的介紹一下吧。

1、把零件放入浸滲罐中。

2、真空處理：開動真空泵，真空壓力在-0.09MPa以上，用真空把零件微孔或裂紋內的空氣（或水、油等）抽出，抽真空時間為5分鐘。

3、用真空把膠液吸進浸滲罐內，膠液的數量應以浸沒籃中零件為準，卸下真空至常壓。

4、如有必要，開啟壓縮機，用壓縮空氣把膠液壓入零件中的微孔或裂紋內，壓縮空氣壓力根據具體情況而定，如果沒有特殊要求，壓縮空氣壓力在0.1-0.4MPa即可，時間5分鐘。浸滲后打開放空閥卸壓。

如果你在使用浸滲設備的過程當中，還有什么疑問的話，歡迎前來咨詢我們

No matter what kind of industrial-use item, if there is any problem in use, it needs to be solved in time. Some defects cannot be solved casually, but must be solved by professional equipment. Impregnation equipment is such a type. What, it has a good solution for the pores and looseness of many items. Let me introduce it in detail below.

1. Put the parts into the impregnation tank.

2. Vacuum treatment: Start the vacuum pump, the vacuum pressure is above -0.09MPa, use vacuum to extract the air (or water, oil, etc.) in the micropores or cracks of the parts, and the vacuuming time is 5 minutes.

3. Use vacuum to suck the glue into the impregnation tank. The quantity of glue should be based on the parts in the immersion basket. Remove the vacuum to normal pressure.

4. If necessary, turn on the compressor, and use compressed air to press the glue into the micro-holes or cracks in the parts. The compressed air pressure depends on the specific situation. If there are no special requirements, the compressed air pressure can be 0.1-0.4MPa. , the time is 5 minutes. After infiltration, open the vent valve to relieve pressure.

If you have any questions in the process of using the infiltration equipment, please come to consult us