隨著浸滲設備使用的越來越廣泛，市場的需求也在增加。采用先進的浸滲工藝，可使零部件的設計薄壁化，可承受高壓至零件爆裂，使以往需要返工的比例降小。生產成本也降低了。那么浸滲設備該如何保養呢？請看下文：

1、制冷機在室溫大于25℃時打開，日夜不能關閉。  

2、制冷機在每天工作時關閉，下班時打開。  

3、儲液罐內膠液要奄沒制冷盤管。  

4、真空泵油剛用1個月后要更換，以后每2個月更換一次。  

5、整套設備要使用清潔的壓縮空氣。  

6、清洗缸和熱水固化罐內的水要定期更換。  

7、制冷空調每年使用時要查驗一次。  

8、浸滲罐密封圈要常年有一根備用。  

9、汽缸定期加潤滑油。  

10、浸滲罐斜塊定期涂黃油。 

11、熱水固化罐重新加水后要把PH值調整到5左右。  

12、每天工作前打開隔離罐底的閥門，排放廢液，10分鐘關閉。

As the infiltration equipment is used more and more widely, the market demand is also increasing. The use of advanced infiltration technology can make the design of parts thinner, and can withstand high pressure until the parts burst, so that the proportion of rework required in the past is reduced. Production costs are also reduced. So how should the infiltration equipment be maintained? See below:

1. The refrigerator is turned on when the room temperature is greater than 25°C, and cannot be turned off day or night. 

2. The refrigerator is turned off during get off work every day and turned on when off work. 

3. The glue in the liquid storage tank should be close to the cooling coil. 

4. The vacuum pump oil should be replaced after just one month of use, and every two months thereafter. 

5. The whole set of equipment should use clean compressed air. 

6. The water in the cleaning tank and the hot water curing tank should be replaced regularly. 

7. Refrigeration and air conditioners should be inspected once a year when they are used. 

8. The sealing ring of the impregnation tank should have a spare one all the year round. 

9. The cylinder is regularly lubricated. 

10. The oblique block of the impregnation tank is regularly greased with butter. 

11. After the hot water curing tank is refilled with water, the PH value should be adjusted to about 5. 

12. Open the valve at the bottom of the isolation tank before working

以上12點就是對浸滲設備的維護，浸滲設備和其他設備一樣，用久了都是要維護的，不然就會出現問題，導致不能正常工作。